Wanted to buy. Thick Katana Tsuba

[Chishiki]

Hi.  I am in need of a very thick katana tsuba.  Prefer iron and on the lower cost spectrum.  Shipping is to Australia.   Please message me if you have something.  FYI they need to be 7mm or more thick.  Thanks Mark

[Shugyosha]

Hi Mark, silly question but can you not use seppa if you are trying to fit the tsuba to a koshirae? 

[Chishiki]

3 hours ago, Shugyosha said:

Hi Mark, silly question but can you not use seppa if you are trying to fit the tsuba to a koshirae? 

Hi.  This sword came to me without tsuba.  The gap is over 1cm.  In fact I have another sword with the same problem,.   Mark

[Dave R]

 I think you will find that multiple seppa are your friend here! Either side of a normal Tsuba, which is what was usually done at the time.

[Curran]

8mm at the seppa dai.

about 1 cm at the mimi. 

but not cheap.

[ROKUJURO]

Not so expensive. 7,2 mm thick, 71 mm diameter:

 

TSUBA  TX7105987 from member Artur: https://www.flickr.com/photos/189643573@N05/albums

[Chishiki]

5 hours ago, Curran said:

8mm at the seppa dai.

about 1 cm at the mimi. 

but not cheap.

Nice tsuba Curran.

[Chishiki]

1 hour ago, ROKUJURO said:

Not so expensive. 7,2 mm thick, 71 mm diameter:

 

TSUBA  TX7105987 from member Artur: https://www.flickr.com/photos/189643573@N05/albums

Hi Jean.   Sent you a pm.

[Shugyosha]

One on Aoi if you’re still looking: https://www.aoijapan.com/tsuba-mumeiowari/